answersLogoWhite

0

there are three bolts on the top of the strut tower. There are two bolts going through the bottom. There are also the brake line brackets. Just remove all of those, and pull off the strut. if you have the cartridge only, you will nees a spring compressor to swap that. To install it, just put everything back... TIGHT. You will need an alignment when finished, the camber will be screwed.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the PCV valve on a 1991 dodge dynasty 3.0 engine?

The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.


What are the size of the speakers in a 1991 Dodge Dynasty?

I believe its 6"


A diagram for a 1991 Dodge Dynasty with a 6 cylinder 3point 3 liter engine?

a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine


Whats wrong 1991 dodge dynasty starts then dies?

what is a controller in 2.5 motor in a dodge


What would it cost to replace all four struts on a 1991 Toyota Camry?

I believe about $800 at least with struts only and plus $400 if you want to replace springs too.


How do you replace the brake lights in a 1991 Dodge Dynasty?

What you need to do is open the trunk. Then you need to remove the liner in the back of the trunk closest to you then you can see the wires the twist out.


Where is the fuel pump for a 1991 dodge dynasty 3.3?

The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.


Does the dodge dynasty 1991 3.3 have an emergency fuel shut off?

No.


Where is the starter relay for a 1991 dodge dynasty 3.3 liter?

The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.


Will an automatic transmission from a 1991 Dodge Dynasty 3.3 interchange with a 1993 Dodge Caravan AWD 3.3?

NO.


Speedometer bounces on 1991 dodge dynasty?

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.


Where is the fan speed relay on a 1991 dodge dynasty?

It is inside the ECM Module