answersLogoWhite

0

To replace the tailgate on a 1997 GMC Sonoma, start by lowering the tailgate fully and removing the retaining clips or bolts from the hinges using a socket wrench. Once the hinge bolts are removed, lift the old tailgate off the hinges. Position the new tailgate onto the hinges, then secure it by reinstalling the bolts or clips. Finally, test the tailgate to ensure it opens and closes smoothly.

User Avatar

AnswerBot

6mo ago

What else can I help you with?

Related Questions

How do you replace the tailgate cables on a 1998 GMC Sonoma?

The tailgate latch comes off with the cable. It is one piece.


How do you replace cables on tailgate of 2000 gmc sonoma?

To replace the cables on the tailgate of a 2000 GMC Sonoma, first, ensure the tailgate is fully open. Remove the plastic covers at the tailgate hinges to access the cables. Disconnect the old cables by unhooking them from the tailgate and the vehicle's body. Finally, attach the new cables by reversing the removal process, ensuring they are securely fastened before closing the tailgate.


How do you change fuel vapor sensor on a 1997 gmc sonoma?

To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.


Where is the crank position sensor located on a 1997 gmc sonoma 2.2?

were is csp on gmc sonoma 2.2


Where can I find a diagram for 1997 GMC Sonoma?

You can find a diagram for a 1997 GMC Sonoma in the owner's manual. You can also find it at various auto stores.


What is the firing order for a 1997 GMC Sonoma 2.2?

1342


What is the fuel tank capacity of a 1997 GMC Sonoma?

14 gal


What is the clunky sounds in the rear suspension of your 1997 GMC Sonoma 4x4?

gears?


Where is the bank 2 oxygen sensor on a 1997 GMC Sonoma?

behind the cat


How do you change the taillights on a 97 GMC Sonoma?

You will need to open the tailgate and the screws that hold the Tail light in will be seen on the side of the fender in the tailgate opening.The light will then pull back as a unit and the bulb sockets will be exposed.


Where is the ECM located on a 1997 GMC Sonoma?

Should be under the hood on the pasenger side.


How do you remove the bench seat on a 1997 GMC Sonoma SL?

remove the bolts buddy.... lol

Trending Questions
Where can a copy of the Emissions info label and the vacuum routing label be obtained for a 1982 Chevy Caprice with a 229 CID motor? What could cause a 1998 Cadillac Catera to take off very slowly when you floor it? How many quarts of oil does a 2006 Chevy Tahoe hold? If you lock yourself out of your 1993 Ford Tempo what is the easiest way to get in without ruining anything? Your 2002 F350 has steering wheel pulls The steering wheel pulls right or left as you are driving down the road All front end components are good? Where is fuse box on 2007 F 150? How do you know what fuel pump your 1999 blazer takes? Will a 1994 Mustang Gt 5.0L motor and trans fit in a 1997 Ford F150? How do you convert Australian sizes to American sizes? What size are the Speakers in a 2003 dodge ram 1500? How much does it cost to replace the starter on a 1999 Grand Cherokee Loredo? Where is a tcc soleniod for Chevy venture for Chevy 2001 venture? Is the 2002 dodge Dakota sport 3.9 engine an interference motor? Where is the windshield wiper governor on a 1989 Ford F-150? How do you fix the car if it cuts off when you put it in gear and it cuts off? What would cause a 1996 Dodge 1500 318 Ci to overheat for a couple minutes then drop back down to normal temps? How do you open the hood on a Massey Ferguson 1635? How do you change the headlight bulb on a 1998 dodge stratus? Where is the factory anti theft alarm on a 2002 Chrysler Sebring? What tools do you need to change a power steering pump in a 92 Grand Prix 3.1 liter V6?