To replace the hood cable in a 1998 Mercury Sable, start by opening the hood and disconnecting the battery for safety. Remove the inner fender liner or any necessary panels to access the cable's routing. Detach the old cable from the latch mechanism and pull it out through the firewall. Install the new cable by threading it through the same path, securing it to the latch mechanism, and reassembling any panels or components you removed.
1999 mercury sable horn replacement
Replace auto lamp module.
You don't as it does not have a cable. You replace the speed sensor instead.
The window washer pump should be located in the bottom of the washer reservoir for the 1998 Sable. The reservoir may have to be removed to replace it.
In a 1998 Mercury Sable : The transaxle is the transmission on your front wheel drive Mercury Sable it is located in the engine compartment , on the drivers side , bolted to the engine
According to the 1998 Mercury Sable Owner Guide : ( 16.0 U.S. gallons )
it does not have cable, it is vaccuum and acuator motor driven
front of the motor
The transmission ( or in the case of your front wheel drive 1998 Mercury Sable , the " transaxle " ) is located in the engine compartment , on the drivers side , bolted to the engine
Pull off the upper intake plenum and you will have access to the plugs and wires.
R134a
All 1998 Mercury Sable vehicles have a ( 16.0 U.S. gallon fuel tank ) * according to the owners manual *