0
To replace the battery the first thing you want to do is disconnect the negative battery cable and then the positive cable. The next thing you want to do remove the 2 bolts from the support bar that crosses over the battery. This will allow you to move it out of the way. The last thing to take off is the bracket that holds the battery down and keeps it from moving. This is located at the bottom of the battery and kind of looks like a tab. Remove the 1 bolt and then take out the battery. To put the new battery in just do it all the steps backwards.
What else can I help you with?
how much can i get to junk my car.......1992 cutlass ciera?
The Kelley Blue book on a 1992 Oldsmobile Cutlass Ciera ranges from $1825 - $2175.
Does a 1992 Cutlass Ciera have a fuel pump reset switch?
no
Where is the location of the ignition control module for a 1992 cutlass ciera?
Under the coilpacks
Where is the flasher relay on a 1992 Oldsmobile cutlass ciera?
Sometimes the flasher relay on a 1992 Oldsmobile Cutlass Ciera is located in the fuse box. Other times it may be located under the dash near the steering column.
How to replace idler pulley on 1992 Olds Cutlass Ciera?
take off the belt and there is one bolt take it off and put a new one one.
Where is the thermostat on a 1992 Oldsmobile cutlass ciera?
On the 3.3L V6 it is under the radiator cap.
Is the 1992 Cutlass Ciera front wheel drive OR rear wheel drive?
Front wheel
You just had your alternator replaced and also recently the crankshaft sensor in your 1992 Olds Cutlass Ciera yes and now it cranks but won't start what is wrong with it now?
check your battery or you spark plugs
Why would a 1992 Olds Cutlass Ciera crank but not start?
Cracked distributer cap or fuel pump
What would cause the horn to not work on a 1992 olds cutlass ciera. if i connect the wire directly to the battery it blows continuously. i replaced the steering column.it didn't work before then.?
Run a breaker button from horn to car interior to battery
How do I Replace the Engine mounts for 1992 cutlass Ciera?
To replace the engine mounts on a 1992 Cutlass Ciera, start by securing the vehicle on a level surface and lifting it with jack stands. Remove any components obstructing access to the engine mounts, such as the air intake or exhaust. Use a jack to support the engine, then unbolt the old mounts from the engine and frame. Install the new mounts in the reverse order, ensuring they are properly aligned and tightened to the manufacturer's specifications.
Type of Oil 1992 Cutlass Ciera?
Mobil 1, 10w30, High Mileage. Expensive, but you won't be sorry.
