answersLogoWhite

0

You didn't say what year you have but, later models require removing the door panel, disconnecting the wire harness, removing the detent spring and drive out the two hinge pins. The spring will need a special tool to replace.

You don't want to replace the hinges unless you have no choice. The original hinges are welded in to the door and the cab. They can be replaced but it is a expensive job. In most cases you can replace the hinge pins and bushings to restore the hinges back to normal. The pins and bushings are available at your local auto parts store.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Tire pressure for 2004 Chevy blazer?

Listed on the driver's door post.


How do you replace a hinge pin on a 1987 Chevy blazer?

break off the bottom bushing that hold door pin pick up on the door slightly use a hammer and screw driver to drive pin out and replace


How do you align 2004 Chevy Blazer door?

Replace the hinge pins and bushings.


Tire size 1997 Chevy 4wd blazer?

Listed on the driver's door post.


How do you replace a door handle on 98 Chevy blazer?

Need to know inside or outside door handle.


How do you replace the rear vent window on a 2001 Chevy Blazer LS 4x4 2 door?

You can replace the rear vent window on a 2001 Chevy Blazer LS 4x4, 2 door with Direct Fit Power Window Regulators.


How do you replace an electric blend door in a Chevy blazer?

Remove the dash assembly to gain access to the blend door actuator.


What is the gross vehicle weight rating for a Chevy s-10 blazer?

Listed on a placard on the driver's door post.


What is b1023 code mean in Chevy Blazer?

B1023: DDM(driver door madule) Integral switch malfunction


IS A 1987 CHEVY TRUCK DOOR INTERCHANGEABLE WITH A 1988 K5 BLAZER?

Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988


Suggested Tire size for 2000 Chevy Blazer 2 door?

look on the driver side door the tire size should be 235x75x15 or 235x70x15


How do you repair driver side door latch on frame body of 200 Chevy blazer?

From your question, it seems as if you're referring to the catch which the door latches onto. Honestly, take it off (IIRC, it requires a T40 Torx bit) and replace it.