0
The tweeter speaker is held in by 2 of the 3 nuts that hold the mirror on the car. Remove the nuts with a 10mm socket wrench. The tweeter speaker has a couple of inches of cable, set it to the side. The 3rd nut is located in the door jamb under a rubber cover, remove the cover and then the nut with the 10mm wrench.
The mirror base is attached to the outside of the car with black weather caulking, rocking the old mirror body a few times should loosen it.
The interior door panel must be loosened (maybe removed) as the cable runs about 4" under the panel. There are screws under the armrest, 2 at the base of the door panel, one under a tab in the door handle, one under a cover a few inched below the tweeter speaker. All are removed with a mid sized Phillips screwdriver.
The mirror power cable goes into the door about 4" under the plastic weather seal. Pull back the plastic and unplug the power cable. The entire old mirror assembly can now be removed. Insert the new mirror and run the power cable as the old one was run and plug it in. It is a good idea to test the power to the mirror before closing up the panel.
Reverse the steps, reseal the plastic on the door, reinstall the door panel making sure the panel seats properly into the window channel. Push ithe mirror into place (seal if a seal is not provided the way the mirror was originally sealed against the outside of the car. Tighten the 3 nuts to hold on the mirror, remember to reinstall the tweeter speaker in the mirror post. Reinstall the tweeter cover, it just pops back into place, hook in the bottom and line the post up to the hole and pop it in.
What else can I help you with?
How do you replace driver side Mirror motor on 1999 bravada?
you can not pea brain
How can you remove the driver side mirror from the housing for a 1999 Toyota Camry?
do it yourself dont ever try to ask this question again.
Where is the thermostat located in a 1999 Toyota Camry and how do you replace it?
where is the thermostat located in a 1999 Toyota Camry located and how do you replace it.
How do you replace the glass on the driver side power mirror 1999 mercury cougar?
the mirror should just pop out, remove the two heating wires and install the new mirror
Power windows on 1999 Camry driver window won't roll up what should you do?
The power windows on a 1999 Toyota Camry's driver's side window may not roll up if the fuse or motor are bad. You should replace the fuse or take it to a local dealership for diagnosis.
How to Replace a Toyota Camry windshield wiper switch?
? wiper switch toyota camry 1999 replace
How do you put a window in the driver's side of a 97 Honda Civic?
how to replace a mirror on a 1999 Honda civic two-door.
What is the average costs to replace the radiator in a 1999 Toyota Camry?
cost to replace the radiator in my 1995 4 cyl. Camry today will be $220.
How do you replace the driver side mirror on a 1999 Olds Aurora?
You can replace them with original replacement parts sold on eBay or aftermarket side mirrors sold in reputable auto parts shop.
Step-by-step of how to replace driver's side mirror on 1999 Chevy Malibu?
To replace the driver's side mirror on a 1999 Chevy Malibu, first, ensure the vehicle is turned off and disconnect the negative battery terminal. Remove the interior door panel by unscrewing any visible screws and gently prying off the panel clips. Disconnect the electrical connector for the mirror, then remove the mounting bolts securing the mirror to the door. Finally, install the new mirror by reversing the steps: attach the new mirror, reconnect the electrical connector, and reassemble the door panel.
How do you replace the inner tie rods on a 1999 Toyota Camry?
replace inner tierod on '99 camray
How do you replace the powered driver's side mirror on a 99 Mazda 626?
To replace the powered driver's side mirror on a 1999 Mazda 626, start by removing the door panel. This typically involves unscrewing any visible screws and carefully prying off clips. Once the panel is off, disconnect the wiring harness for the mirror, remove the bolts securing the mirror to the door, and take out the old mirror. Install the new mirror by reversing the steps: secure it with bolts, reconnect the wiring, and reattach the door panel.
