should be 2 Phillips head screws on the out side of the lense and 2 Phillips head screws on the inside jamb of the truck bed (put down the tail gate to expose these 2) after you remove all 4 screws the whole thing should come right out. Then the bulbs come out by turning the sockets (I think it's a quarter turn for each one of the 3 bulbs). Then put the bulbs in the new lense and place back and replace all four screws.
how to replace a blend door actuator on a 1999 ford ranger
how to replace oil pump in a 1999 ford ranger xlt ext cab 4.0
very carefully.
Lower the tailgate, and you will see the bolts on the bed side of the taillight,remove the bolts. there are two of them and pull out tailight assembly.
Do you still need an answer? yes
In my 2002 ranger, the starter is bolted to the bell housing on the driver's side of the transmission. there are two 15mm bolts holding it in.
You have to replace the entire assembly.
From inside the trunk pull back the carpet and get access to the tailight assembly. Remove the fasteners on the tailights then unscrew the bulbs and replace.
Inspect at 120,000 miles , replace if needed ( Ford maintenance and the Gates website ) for the 2.5 liter , 4 cylinder , in a 1999 Ford Ranger
should be a catalyst on either driver or passenger side door
you can not pea brain
you have to pull the engine.