in order to take the mirrow off first you have to open the door and on the front of the inside door where the mirrow is there's a screw remove it and remove the plastic housing which is held down by the screw then you should be able to see the electrical plug which operates the mirrow disconnect it by pulling out the retainer clip also you should be able to see three more screws these hold the mirrow in place unscrew them now you should be able to pull the mirrow out from the outside. hope this helps. butkus.
To replace the driver's side mirror on a 1998 Subaru Legacy, start by removing the door panel. First, unscrew any visible screws and gently pry off clips to detach the panel. Once the panel is off, disconnect the wiring harness for the mirror. Remove the three bolts securing the mirror to the door, replace it with the new mirror, and reassemble the door panel by reversing the steps.
Are there any steps on how to change the alternator on a 1198 ford contour?
On the 1996 Hombre, you have to remove the inside door panel. You will see three nuts holding the mirror. Try Advance Auto Parts for replacement mirror (probably same as S-10).
the dipstick for the tranmission is on the drivers side in the back of motor.
drivers side under dash near door
it the main belt on the side of the motor its on the right of the car
http://wiki.answers.com/Q/How_do_you_replace_side_mount_alternator_in_1998_Contour_GL"
This is not the Ford Contour page this is the Escort Page. ========================================================= On a 1998 Ford Contour : The fuel pump shut off switch ( inertia switch ) is located in the drivers footwell behind the kick panel ( there is an access hole ) * the kick panel is the interior trim panel , in front of the front door , beside the drivers left foot
To tighten the driver's side mirror on a 1998 Volvo S70, first, adjust the mirror to a position that allows you to access the screws. You may need to remove the plastic cover or trim around the mirror by gently prying it off. Once exposed, tighten the screws using a suitable screwdriver. After tightening, replace the cover securely to finish the process.
Check the drivers manual, it will show you what fuses are for what.
Replace, flush, or repair, depending on what the problem is.
In the drivers footwell , behind the kick panel ( there is an access hole in the kick panel )