answersLogoWhite

0

The ECM is located behind the glove box. Remove the glove box door. You'll see the ECM. Disconnect the battery. Remove the three plugs on the bottom of the ECM. There are 4 nuts that hold the ECM in. They are 10mm. Remove them and pull out the ECM. Install is just the reversal. Remember to take your PROM from the old ECM and put it in the new one. New ones don't come with the PROM and it's highly probable that a used one will have the wrong PROM installed as each one is programmed to each specific car.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Fuel injector 1989 Pontiac sunbird what controles the fuel injector?

ecm and ing. module


How do you reset the computer in a 1991 Pontiac sunbird gt 6CYL 5 speed manual?

Try taking your positive battery cable off for 3mins or taking out the ecm fuse in the fuse box for 30 seconds.


Will a 1996 firebird ecm work in a 1992 sunbird ecm?

1992 sunbird is obd1,1996 firebird is obd2.Will not work.


1991 Pontiac Sunbird 2.0 has no spark?

Bad Ignition (Spark Plug) Wires. Bad Coil(s). Bad ECM or ECU. Incorrect Spark Plugs. Ground Wire(s) missing or loose. Alternator fault. Bad Battery.


How do you remove the ECM on 1991 Pontiac Bonneville?

To remove the ECM (Engine Control Module) from a 1991 Pontiac Bonneville, first disconnect the negative battery cable to ensure safety. Locate the ECM, which is typically found under the dashboard or in the passenger side footwell. Unplug the wiring harness connected to the ECM and remove any screws or bolts securing it in place. Finally, carefully pull the ECM out of its mounting location.


Where is the computer on a 1992 Pontiac sunbird?

In a 1992 Pontiac Sunbird, the engine control module (ECM), which functions as the computer, is typically located under the dashboard on the driver's side. It is usually mounted to the firewall or near the steering column. Accessing it may require removing some panels or covers for better visibility and reach.


Idle speed adjustment for a 1991 Chevy cheyene pickup?

replace the ecm


Replace the ecm on 91 cutlass ciera?

The ECM is located behind the glovebox on a 1991 Cutlass Ciera. Pull the glove box out to see it. Once located remove the mounting hardware and unplug it from the car. Replace the unit.


How do you fix the ECM failure?

replace the ecm


Where is the ECM located on a 2003 Pontiac Montana?

The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.


Why does my 92 Pontiac sunbird have no spark with good injector pulse?

Defective Coil pack, defective spark wires, plugs. Bad ground(s). Open (electrical short) in starting system. Faulty Ignition switch, ECM, other.


How do you fix the ecm?

you can't fix an ecm, you have to replace it.