Looking at the headlight assembly, on the side of the burnt out directional bulb, look at the back of the headlight. To the side of the headlight adjusters, on the side wall of the wheel well you will see a 10 mm nut. That nut is the only thing holding the directional assembly on. Take that nut off and jiggle the assembly. It will pull out to the side. Replace bulb and reinsert the assembly. Be carefull that you get the plastic bayonet shaft into the correct hole along with the stud that has the nut on it. tata G
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
How do you replace a 1996 Grand Prix front bumper?
No , rear wheel drive
how to replace front wheel bearing on 1996 Hyundai elentra
take the wheel well out first then reach in and turn bulb socket
Remove the headlight by taking out the three 10mm bolts on top and unscrew the bulb from the backside.
6x8 front 6x8rear
Yes , one for the driver and one for the front passenger
how to replace high/low beam, turn signal lever on 1996 subaru outback wagon
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck
If the turn signal bulbs work but just do not flash, replace the Flasher Relay.