Pull electrical spade connector from back of bulb
Remove rubber cover
Bulb is held in by a spring clips on either side - feel for the clip underneath and to each side, press towards the centre and pull out
Remove old bulb and put in new.
Replace spring clip, rubber seal and spade connector.
It may be easier to undo the two bolts that hold in the headlight first, certainly in the 06 model, the fuse box is a little close to the headlight for easy access.
You cannot replace the headlight bulb. You need to buy a new headlight unit.
open the lift-gate and take off the tail lamp
mine is on the left side of the front left bulb housing
To remove the side lamp bulbs on a Daewoo Matiz, first, locate the side lamp assembly, usually found in the front fender or bumper area. Gently twist or pull the assembly out of its housing. Once removed, disconnect the wiring harness and then twist the bulb holder counterclockwise to release the bulb. Replace the bulb as needed, reassemble the parts, and ensure everything is securely in place.
To replace the headlamp bulb on a 2008 Kia Amanti, first, open the hood and locate the back of the headlamp assembly. Disconnect the electrical connector from the bulb and remove the retaining clip or twist the bulb socket counterclockwise to release it. Replace the old bulb with a new one, ensuring not to touch the glass with your fingers, and then reassemble by reversing the steps. Finally, test the headlamp to ensure it is functioning properly.
with your hands ?
ask someone else to do it
To replace the headlamp on a Citroën Xantia, start by opening the hood and locating the headlamp assembly. Remove the screws or clips securing the headlamp, then carefully pull the assembly out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, and secure the headlamp assembly back in place before testing the new bulb.
To replace a headlamp bulb on a 2007 Nissan Murano, first, turn off the vehicle and open the hood. Locate the back of the headlamp assembly, then remove the electrical connector by pulling it straight off. Twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one, taking care not to touch the glass. Reinsert the bulb socket, reconnect the electrical connector, and test the headlamp before closing the hood.
1/4 turn to release the old bulb.
The backup light on a Daewoo Matiz is typically located in the rear taillight assembly. It is usually positioned near the bottom of the taillight, alongside the brake and turn signal lights. When the vehicle is in reverse, the backup light illuminates to signal other drivers of the vehicle's movement. If you need to replace the bulb, access may require removing the rear taillight assembly.
very carefully very carefully