Disconnect both ends of cable, unbolt drivers side of seat, prop seat up with a block of wood, pull back carpeting, pull shift cable out through the top. Reverse procedure to install. Cable adjustment is made at the transmission end of sheathing.
To replace the bonnet release cable on a 2000 Fiat Punto, first, open the bonnet using the manual release if possible. Disconnect the old cable from the release lever inside the vehicle and the catch mechanism at the front of the car. Install the new cable by routing it through the same paths and securing it to the lever and catch. Finally, test the new cable to ensure proper operation before closing the bonnet.
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
You have to replace a whole thing, not only a cable
I need to repair the gear shift cable in side a 2000 toyota corolla. How do you get in side the gear shift box to repair the cable end?
The cable runs through and is coiled inside the motor. It is advised to replace as an assembly.
You will have to replace the complete window regulator assembly.
Get a manual on your car from AUTOREPAIRMANUALS.COM
You unscrew the bracket holding the cable with a T45 size torque wrench and replace it with the correct size cable. When I replaced mine the washer stuck to the bolt so I had to pry that off as well.
This info is listed in your owner's manual. Don't have on the replace them at 75,000.
You use tools and a manual.
Buy a Manual. ;)
Buy a Manual. ;)