You unscrew the bracket holding the cable with a T45 size torque wrench and replace it with the correct size cable. When I replaced mine the washer stuck to the bolt so I had to pry that off as well.
To replace the cables on the tailgate of a 2000 GMC Sonoma, first, ensure the tailgate is fully open. Remove the plastic covers at the tailgate hinges to access the cables. Disconnect the old cables by unhooking them from the tailgate and the vehicle's body. Finally, attach the new cables by reversing the removal process, ensuring they are securely fastened before closing the tailgate.
This was a repair available via a recall repair from Chevy involving a tailgate problem.
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
A 2000 Ford Ranger tailgate is typically interchangeable with tailgates from 1998 to 2005 models of the Ford Ranger. Additionally, the 1997 model may also fit, but it's essential to verify compatibility based on specific features and styles. Always check for any differences in design and mounting points before making a swap.
To change brake/tail light you need to remove the two screws in the tailgate jam, by the upper support cable of the tailgate (much easier with tailgate lowered!) and the tail light housing should pop out. The socket for the light is a quarter turn counter clockwise and the bulb is exposed.
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
to replace tail light lens on a ford pickup. lower tailgate on side of bed that is hidden when tailgate is closed, you will see 2 screws. remove these screws and you can pull tail light out of bed.
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Wheel bearings? 4X4 ? 4X2?
Drop the tailgate and look at the side of the lens for screws.
You have to replace a whole thing, not only a cable