answersLogoWhite

0

  1. Remove the HVAC rear module auxiliary assembly.

  2. Disconnect the electrical connectors from the rear blower resister auxiliary.
  3. Remove the air outlet duct from the rear blower motor controller auxiliary.
  4. Remove the screws from the blower motor rear resister auxiliary.
  5. Remove the rear blower motor resister auxiliary.
  6. Replace the resister and install new thermal gasket.................
User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the blower resistor card on a 2003 Chevy Trailblazer?

resistor card is under the glovebox. Remove glovebox door. Should be 2 screws I think holding resistor card in place.


Where is the blower resistor on a 2005 Chevy Trailblazer?

Blower resistor is behind the blower motor up against the firewall you can see wires hanging down from it. (Mite be called blower control module in 2005 models.)


2003 Chevy trailblazer blower motor stuck on hi even with engine off?

Never mind....It was the blower resistor shorted on hi......


Where is the rear blower motor resistor location for a 2003 Chevy trial blazer ext LT?

The rear blower motor resistor location for a 2003 Chevy Trailblazer Ext LT is beneath the passenger side of the dash.


What is the labor time for a blower motor resistor on a Chevy Trailblazer?

About 15 minutes. Easy and simple. Read all about it at www.trailvoy.com


Where is the switch for the blower the located in a Chevy Trailblazer?

If you do not have fan speeds it may be a fuse or the blower motor resistor. For help with the issue visit our enthusiasts forum at www.trailvoy.com


How do you replace the blower motor resistor on a 2002 Chevy Trailblazer?

Try dropping the glove box door to get access. You should at least be able to see it at that point. The resistor is just two bolts and a electrical connector after that. The hard part is getting to it.


How do you replace your blower motor resistor on a 2003 Chevy Trailblazer?

The resistor is located under the hood, on the firewall, passengers side. Unplug the wire harness from it, remove the small screws holding it in place, remove it from the housing. Reverse procedure for install.


Removal of blower motor resistor on 2003 Chevy silverado?

Replace shoes brake 2003 Chevy


How do you replace a resistor heater blower in a 1994 Chevy van?

To replace the resistor heater blower in a 1994 Chevy van, first disconnect the vehicle battery to ensure safety. Locate the blower motor resistor, which is typically found near the blower motor under the dashboard on the passenger side. Remove the screws or bolts holding it in place, disconnect the wiring harness, and then replace it with the new resistor. Reassemble everything, reconnect the battery, and test the blower to ensure it operates properly.


How do you replace a blower motor resistor on 02 Chevy Prizm?

To replace the blower motor resistor on a 2002 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the lower dashboard panel to access the resistor, which is typically located near the blower motor. Disconnect the wiring harness from the resistor, unscrew it from its mounting position, and replace it with the new resistor. Finally, reassemble the dashboard panel and reconnect the battery terminal.


How do you replace blower motor resister on a 2001 Chevy Trailblazer?

Look at the link I posted, that should help you. (: