it is on the back of the transaxle of the transmission its an oval piece with a two part wire going into it.
I have a 1992 acclaim, the speed sensor is located on the right hand (passenger) axle. Look on the back side of the axle,about 6 " down from the transmission, you see a lump on the housing, with 2 or3 wires leaving the top.
On a 1993 Plymouth Acclaim, the speed sensor is typically located on the transmission. Specifically, it is mounted on the transmission case, near the output shaft. To access it, you may need to raise the vehicle and remove any components that obstruct visibility, such as the air intake duct. Always refer to a repair manual for specific instructions and safety precautions.
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
It is located on the backside of the engine/transmssion assembly against the firewall. It is screwed into the diff houing and is easier to get to from beneath the car.
It is not adjustable. It is computer controlled. If idle speed is incorrect you have a vacuum leak or a sensor/solenoid issue.It is not adjustable. It is computer controlled. If idle speed is incorrect you have a vacuum leak or a sensor/solenoid issue.
To fix the speedometer and odometer on a 1991 Plymouth Acclaim, first check the vehicle's speed sensor, as a faulty sensor can cause both instruments to stop working. Inspect the wiring and connections for any damage or disconnections. If the speed sensor is functioning properly, the issue may lie within the instrument cluster, requiring repair or replacement. Additionally, ensure the vehicle's fuses are intact, as a blown fuse could also affect these components.
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
If you are refering to the vehicle speed sensor (VSS) it is on tranny by where the axles are
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
To change the speed sensors on a 1996 Plymouth Breeze, first, locate the vehicle's speed sensor, which is typically found on the transmission. Disconnect the negative battery cable for safety, then remove the electrical connector from the sensor. Unscrew the sensor using the appropriate socket or wrench, replace it with the new sensor, and reattach the electrical connector. Finally, reconnect the battery and test the vehicle to ensure the new sensor is functioning correctly.
how do you replace a 2004 buick rendezvous input speed sensor