0
To replace the starter in a 1986 Jeep Comanche, first disconnect the negative battery cable to ensure safety. Next, locate the starter beneath the vehicle, remove the electrical connections (typically one or two bolts and a wiring harness), and unbolt the starter from its mounting bracket. Install the new starter by reversing the removal process, ensuring all connections are secure before reconnecting the battery.
What else can I help you with?
Egr valve in 1986 jeep comanche?
The 1986 Jeep Comanche EGR valve is located on the outside of the air cleaner housing. The valve can be found on the back of the housing.
How many years did they make jeep Comanche?
from 1986 to 1992.
Would an engine from a 1988 jeep Comanche go into a 1991 Jeep Cherokee?
no. 1986 to 1990 sorry
Where is the fuel pump located on a 1986 Jeep Comanche?
inside gas tank.
Where is the horn on an 1987 Jeep Comanche?
It should be right behind the grill. It is on a 1986.
How do you replace clutch slave cylinder on 1987 Jeep Comanche?
you have to pull the transmission
What size is the top bolt an the starter of a 1987 jeep Comanche?
The top bolt on the starter of a 1987 Jeep Comanche is typically a 13mm size. However, it is advisable to double-check with a service manual or specific vehicle resources, as variations may exist based on engine type or modifications.
When was Jeep Comanche created?
Jeep Comanche was created in 1985.
Where is the fuel flter located on a 1986 Jeep Comanche?
It is under the back of the cab on the inside of the unibody rail.
Your 88 Jeep Comanche wont start it has spark and the timing seems to be correct and the fuel pressure is good too?
If a 1988 Jeep Comanche will not start even though there is spark and the timing seems to be correct and the fuel pressure is good, check the starter solenoid. Even though all the other factors are good, the starter solenoid might not be telling the starter to engage.
How do you adjust valves in an 1988 jeep Comanche?
You can't adjust valves, all you can do is clean or replace them.
What type of oil in an 86 jeep Comanche 2.8l engine?
The recommended type of oil in a 1986 Jeep Comanche 2.8 liter engine is 10 W 30. This oil can be purchased at any auto parts store.
