the screws come off and you replace it
To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.
check your bulbs
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
To replace the taillights on a 2001 Nissan front first prop the hatch open. Locate the rear lights plastic housing and remove them to find the bulbs. Replace the bulbs.
you probally need to replace the bulbs
AnswerThe bulbs for the brake lights are usually separate from the normal tail light bulbs. Check and replace the brake bulbs first, and if they are still not working examine the fuses, switch and wiring.
check fuses under dash panel and for short if wired for trailer
Remove the tail light housing and replace the bulbs.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
Open the trunk....inside the trunk, on the back side are plastic covers that you can remove...there you will find your bulbs....find the brake light bulbs and remove them and replace them with new bulbs, then replace the covers. Don't forget about the 3rd brake light ...check it to see if new bulbs are needle. Also, if all of your brake lights aren't working...all at the same time...you might want to check your fuses. If replacing the bulbs and checking the fuses doesn't do the trick, the next step is to check the brake light switch above the brake pedal. And lastly...depending on the age of the car, and the last time you replaced your bulbs...you might want to check all those bulbs
The light assy has to be removed and the bulbs removed from the back.