To replace the throttle position sensor (TPS) on a 1999 GMC Suburban with a 454 engine, first disconnect the negative battery cable to ensure safety. Locate the TPS on the throttle body, remove the electrical connector, and unscrew the sensor from its mounting. Install the new sensor in the same position, tighten the screws, reconnect the electrical connector, and finally reconnect the battery cable. It's a good idea to check for proper functioning by using a scan tool to verify the TPS readings after the replacement.
take it to a dealer
The throttle position sensor on a 2003 Chevrolet Suburban is located on the side of the throttle body. It notifies the vehicle's computer of the actual position of the throttle plate in relation to the throttle body.
how to replace the throttle position sensor on a 97 nissan altama
How to replace throttle sensor kia spectra 2003
It is located on throttle body, opposite side of where throttle cable is located- Unplug it, remove any screws or bolts holding it on then install new part in reverse order.
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
you dont!
There is no adjustment, they are electronic. You just replace them.It senses the position of the throttle and sends the information to the computer.
It is a part of the throttle body. You have to replace the throttle body if faulty.
The throttle position sensor, TPS should be in about the same position as it was in earlier models - so the "Related Question" below should also be helpful.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
The throttle position sensor is on the drivers side of the throttle body. It is right in the middle with a connector hooked to it and two torx head screws holding it in.