I found this link on Autozone. It shows how to replace the belt. http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280097cee
To replace the idler pulley on a 2004 Saturn Vue, first, disconnect the battery and relieve tension on the serpentine belt using a wrench on the tensioner pulley. Remove the serpentine belt from the idler pulley, then unbolt the old idler pulley from its mounting bracket. Install the new idler pulley, reattach the serpentine belt, and finally reconnect the battery. Always ensure the belt is properly aligned before starting the engine.
where is the slave cylinder located on a 2004 satern vue
underneath the master cylinder for the brakes in the engine bay.
carbertor
To replace the ignition lock on a 2004 Saturn Vue, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing any visible screws. Use a key to turn the ignition to the "On" position, and locate the release tab on the ignition lock cylinder; press this tab while pulling the cylinder out. Finally, insert the new ignition lock cylinder and reassemble the steering column cover before reconnecting the battery.
how much to charge to change a stater on saturn
You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.
put another one in where the old one was.
All of the 4 cylinder Saturn's used a timing chain. All of the V6 Saturn's used a timing belt.
Goodwrench says to "Inspect" at 60,000 miles. I recommend at every oil change. Replace if cracked or damaged...
The 2004 Saturn Vue 2.2L Engine Uses a Timing CHAIN. It is Much better than a belt, and for 2004, Saturn fixed the issue with poor oil pressure on the timing chain and they last much longer than their predecessors.
Here are instructions for a 2004. There should be little, if any difference.