0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you access idler pulley 2004 Chevy Trailblazer?
buy a Honda or Toyota. Hope this helps
What does idler pulley look like on 2004 Jeep liberty?
It is one of those small round items that the belt rides on. The idler is not attached to an accessory such as the power steering or alternator.
How do you put the serpentine belt on for the power steering pump and alternator on a 2004 Dodge Intrepid what needs to be loosened?
loosen the nut on the idler pulley. There is a bolt at 10:00 o'clock from the pulley. Loosen this bolt until you can put the belt on then tighten the bolt till the belt is tight then tighten the nut on the idler pulley. Recheck the belt tension after a day or so..
How do you replace fuel pump on a 2004 Saturn L300?
carbertor
What the constatnt loud noise is in my 2004 trailblazer it gets louder when you rev it its not the tens pulley or the idler pulley?
It could be the clutch fan that is going bad. I had the same issue & the expense of the part and manpower can be $400 to $700.
What belt do you get to bypass the ac compressor on a 2004 scion xa?
You don't use a different belt. If your A/C quits and you don't have the money to fix ot simply don't want to, you get an idler pulley to replace the compressor pulley, remove compressor and use same belt. The idlers are available from Amazon or ebay among other suppliers
How much money to replace a starter on a 2004 Saturn Ion?
how much to charge to change a stater on saturn
How do I put on a serpentine belt on a 2004 dodge ram 4.7 liter?
Start in the upper / center postition and continue clockwise. 1. Over / Right - Generator pulley 2. Outside / Right edge of power steering pump pulley 3. Under the Crankshaft pulley 4. Over the Idler pulley 5. Under / Left Tensioner (pulley) 6. Over / Left A/C Compressor pulley 7. Under Water Pump pulley
How do you replace the serpentine belt on a 2004 dodge ram 2500 turbo cummins diesel?
You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.
What causes power steering pump in KIA 2004 Sedona to make noise?
I had a similar noise and had the idler pulley replaced. Noise still there and mechanic said it was probably the bearings in the pump, probably from overtightening the belt.
How do you loosen the belt to install a new alternator on a 1996 Chevy Cavalier?
On my 97 Cavalier I can use a 15mm box end wrench on the spring tension idler pulley. The idler pulley is in the middle of all the pulleys on the belt. It is right under the engine mount and above the crankshaft pulley. It is difficult to get to, but I can put the wrench on the bolt in the center of the pulley and apply clockwise force (looking at the engine from the passenger side fender) to rotate the idler down. This will loosen the belt. You will need to do the same to re-install the belt. Be careful, the pulley will try to spring up when you remove the belt. Make sure you memorize or draw the belt path before you remove it. If you forget, Advance Auto Parts can print a diagram. It was the same for our 2004 Cavalier. I took the right wheel off and lining behind it.... much much easier! (pulley and belt right there)
How do you install a serpentine belt on a 2004 Chevy Trailblazer?
Loosen the tightner pulley then slide it off. Then do the loosen the pulley and put the new one on. Same way to replace all serpitine belts
