Release the steering column upper shroud from the lower shroud by inserting a thin screwdriver into holes on each side of the column. Lift the upper shroud from the column and unclip it from the bottom of the instrument panel. Depress the plastic tab at the top of the switch with a screwdriver. Lift the switch assembly from the steering column, and disconnect the switch multi-plug on removal.
Fasten seat belts...
Mounted on the turn signal stalk.
replace your mutifunction switch (your signal light switch, your high beam and flash to pass are worn out )
This means that the switch is going bad. You will need to replace the switch that is on your steering wheel or on the turn signal switch.
You can not replace it unless it's an old ford focus.
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
remove the steering column shouds and use a T20 torx screwdriver to take the two T/S switch mounting screws out and replace the switch.
change it from the inside
how to replace water pump on 2001 ford focus
how to replace a front fog light on a ford focus
at is the cost to replace a blower motor on a ford focus
I am assuming you have replaced any defective bulb. If none of the turn signals work, replace the turn signal flasher relay.