0
ondo valve cover, bolts remove valve cover, remove old gasket from valve cover and block. clean both surfaces well. put gasket glue on one side of gasket and install on cylinder head. align valve cover than replace bolts . tighten in a cross pattern until thet are snug. don't overtighten.
What else can I help you with?
Why does a car produce white smoke from under the hood after the engine is off and the temperature gauge is normal?
It sounds like, perhaps, oil is leaking out of the value cover gasket and is vaporizing on the hot engine and manifold. I think if it's an older vehicle, and if you replace the valve cover gasket, you'll cure the problem.
How much does a new head gasket for a 1999 Cadillac Seville SLS cost?
About $40 for the gasket... And about book value of your car to replace them.
How do you change value cover gasket on a 2002 lexus ls 430?
Get out a tool that is shaped like a "T" and pry away the plastic cover that protects your engine. Then, take a razor blade and slice away the valve cover being careful not to hurt yourself. This is not easy, but take your time. Then, install the new valve cover gasket and you're ready to roll!! Then celebrate your big victory with beer and some sex!
Is it worth fixing a blown head gasket or a crack head gasket.?
That depends entirely on how much you value the car.
How do you replace in visual foxpro?
You can use the REPLACE using below code SELECT TableName APPEND BLANK REPLACE FieldOne WITH THISFORM.TEXT1.VALUE REPLACE FieldTwo WITH THISFORM.TEXT2.VALUE REPLACE FieldThree WITH THISFORM.COMBO1.VALUE REPLACE FieldFour WITH THISFORM.COMBO2.VALUE
Difference between Insurance reinstatement and indemnity?
Also known as the Reinstatement Cover and the Indemnity cover, the reinstatement cover means that the insurers will pay to replace the item with a new one which is equal to but not better than the item lost or damaged. This is usually the basis of cover under the Event Assured "all risks" cover, provide the sum insured represent the full replacement cost. Indemnity basis means that the insurance will only pay for the second hand value of the item i.e. what you might get if you sold it. This is its market value, not the written down value, nor what it would cost to replace, and so may be inadequate, particularly if the item is hired and the owner wants a replacement.
What is the torque value for the valve cover gasket on a 2000 Toyota Camry 4-cylinder?
According to Chilton's, the Specification for the Spark Plug Tube Nuts, Which bolts the valve cover on, is 33 lbs. The socket size is 30mm. However, I was told by a friend of mine who is a mechanic that he tightens them at 20 lbs.
What is the junk value for a 1995 dodge spirit?
I just got $250 for my 1995 Dodge Spirit in October 2011. I got the car off a friend when the orginal headgasket went bad at 120,000 miles. I had my mechanic replace the head gasket with a second one. The head gasket I had installed (second head gasket for vehicle) went bad 11,000 miles later. The Dodge Spirit is notorious for having head gasket problems. It wasn't worth putting a third head gasket on it. When a head gasket goes bad on these vehicles you can expect problems with the following: 02 sensor, thermostat, timing belt, and a possible cracked/warped head.
What is the clear cover value for RC water tank?
The clear cover value for the RC water tank is approximately $50.
Is it worth replacing a blown headgasket on a 98 Grand Voyager with 138K miles If I spend 1000 to replace the head gasket won't the lower part of the engine be weaker?
No, it won't be "weaker", but you need to weigh the price against the value of the vehicle.
How do you find a p value when given the focus and directrix?
To find the p-value for a parabola given its focus and directrix, first identify the coordinates of the focus (F) and the equation of the directrix (a line). The p-value represents the distance from the vertex of the parabola to the focus (or the vertex to the directrix), which is half the distance between them. Calculate this distance using the formula for distance between a point and a line, or by measuring the distance from the vertex to either the focus or the directrix. The p-value is then the absolute value of this distance.
If x12 and y 13 what is x-y?
The idea is to replace "x" by its value, to replace "y" by its value, and then to do the calculations.
