0
What else can I help you with?
Where is the PCV valve located on a 2004 Chevrolet Impala?
In the valve cover.
Where is PVC valve located on 2003 Chevrolet Impala LS 3.8?
where is the PVC valve on chevelet impala 2003
Where is the PCV valve on your 1994 Chevrolet Impala?
It is located in the right valve cover.
Where is the power steering bleed valve located at on a 2007 Chevrolet Impala?
It doesn't have a bleed valve for the power steering.
Where is the idle air control valve located on a 2001 Chevrolet Impala?
It is located on the throttle body.
How do you release the fuel pressure on 2001 Chevrolet Impala?
On the fuel rail there is a cap and under it is a schrader valve. Depress the schrader valve.
What is the procedure to determine a collapsed lifter and how do you replace them on a 83 ford crown Victoria with a 302 fi?
If the lifter has failed, the engine will run poorly due to no valve action on that cyl. Confirmation would be to remove the valve cover to see which valve is not working. You will have to remove the intake to get at the lifter, and if you do that, the might be good to replace them all, hopefully the cam is still good. It is possible that the cam is worn also.That can be replace at the same time thru the front of the engine when you strip it.
Where is the PCV valve located on a 2007 Chevrolet Impala 3.9L engine?
Not too sure about the 3.9L, but the 3.5L has none, just a nipple on the valve cover...
Replace PCV valve 79 Chevy impala?
No tools required pull valve from valve cover, pull valve from vacuum line, install new valve.
What are symptoms of bad valve lifter?
on a 98 ford taurus what are the symptoms of a bad hydralic valve lifter
Where is PCV valve on 2008 impala 3.5 v6?
The PCV valve on a 2008 Chevrolet Impala with a 3.5L V6 engine is located on the valve cover. Specifically, it can be found on the driver's side, near the back of the engine. To access it, you may need to remove some components or covers, as it’s somewhat tucked away. Be sure to check your vehicle's manual for detailed instructions if you're planning to replace it.
How do you replace stuck lifter?
To replace a stuck lifter, first, ensure the engine is cool and disconnect the battery. Remove the valve cover and, if necessary, the intake manifold to access the lifter. Carefully remove the old lifter using a lifter puller or magnet, clean the lifter bore, and install the new lifter with proper lubrication. Reassemble the components, ensuring all gaskets are replaced, and then reconnect the battery before starting the engine to check for proper operation.
