You go to the dealership. Take proof of car ownership(registration) and proof of ID (Drivers license) it doesn't cost that much and it can be done there at the dealership in just a few minutes. Answer 2 You may just need to reprogram your keyless keyfob or replace the battery.
Follow the link below to reprogram. Hope this helps. "G"
You cannot reprogram it. A dealer can get you the Master Code if you've lost it.
Open the keyless remote and you will see the battery take it out and replace it with the same size.
how do you program a keyless entry remote to a 2000 Pontiac grandprix programyourremote.com (program your remote.com)
If it's the original transmitter and it has gone out of sync with the vehicle, hold down both the unlock and lock buttons until the car horn honks. This should re-sync. If it's a replacement transmitter, I think the dealer will have to program it.
The receiver is behind the left side of the IP, behind the driver info center
To install a keyless entry system in a 1999 Pontiac Grand Am, first disconnect the negative battery cable for safety. Remove the driver's side door panel to access the wiring harness. Connect the keyless entry module to the door lock and power wires, following the module's wiring diagram. Finally, reassemble the door panel and reconnect the battery before testing the system.
To reprogram a 2000 Jeep Grand Cherokee keyless entry remote, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Within 10 seconds, turn the key to the "Off" position and back to "On" three times, ending in the "On" position. After a chime sounds, press any button on the remote to program it. Repeat this step for additional remotes, then turn the ignition to "Off" to exit programming mode.
Ou812
YOU CAN FINE ALMOST ANY KEYLESS ENTRY ON EBAY AND FOR A GOOD PRICE.. GOOD LUCK.........
yes they do, i have it on mine.
To reset the keyless entry system on a 2005 Pontiac Grand Prix, first, ensure the vehicle is in the "On" position without starting the engine. Then, press and hold the "Unlock" button on the driver's door while simultaneously pressing the "Lock" button three times. Release the "Unlock" button, and the system should beep, indicating a successful reset. Finally, test the keyless entry remote to ensure it's functioning properly.
it has to be done by the dealer. =(