answersLogoWhite

0

To reset the ABS module on a 1989 Ford Bronco II, first disconnect the negative battery cable for about 10 minutes to clear any stored codes. Next, reconnect the battery and turn the ignition key to the "On" position without starting the engine. This allows the ABS system to perform a self-check. If the ABS warning light does not turn off after driving a short distance, further diagnostics may be needed.

User Avatar

AnswerBot

∙ 11mo ago

What else can I help you with?

Related Questions

Will the rear seat from a 86 bronco fit in a 89 bronco?

yes


Your 89 Bronco dies like its out of gas soon after its warmed up you have replaced the fuel filter and coil with no change any suggestions?

fuel pump or the ignition module needs to be replaced


Where is the fuel reset switch in a 89 Ford Bronco II 2.9 liter?

On the passenger side where the carpet goes up under the dash. Pull the carpet back and it will be on the left.


How many gallons does a 1985 bronco hold?

I have an '89 Bronco XLT, it has a 25 gallon tank


Will 85 ford bronco tailgate fit 89 ford bronco?

Yes. The Bronco body style didn't change again until after 1989.


What besides the fuel pump can be wrong with my 1996 Ford Bronco 5.7 Getting Spark not getting fuel?

try replaceing the ingnition switch module located on the distruber(sp) l have an 89 that did the same thing


Can you swap a 2003 5.4 engine into an 89 bronco?

YES!


What type of trans does your 89 bronco ii have?

vehicle has a aoutomatic transmission


Where is the ecm on an 89 bronco?

behind the panel,next to the parking brake.


Will the parts off of a 81 Chevy Bronco XL fit onto an 89?

Chevy/Chevrolet didn't make the Bronco, homie...


Where is fuel module reset switch located 89 firebird?

In a 1989 Pontiac Firebird, the fuel pump reset switch, also known as the fuel module reset switch, is typically located in the trunk area. It can usually be found near the fuel tank or on the rear wall of the trunk, often close to the fuel filler neck. If you're having trouble locating it, consult the vehicle's owner manual for specific guidance.


How do you replace ball joints on A 89 bronco II?

4-wheel drive?