0
To reset the change oil light in a 2008 Toyota Tundra, first turn the ignition switch to the “ON” position without starting the engine. Press the gas pedal three times within five seconds. After this, turn the ignition off and then back on to check if the light has reset. If done correctly, the oil change light should no longer be illuminated.
What else can I help you with?
How do you reset tire light for a 2008 Tundra?
If you have one it's on the drivers side up under the dash by your right knee.
How do you reset the oil change light on 2008 mdx?
To reset the oil change light on a 2008 Acura MDX, start by turning the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then back to the "ON" position to verify that the oil change light has been reset. If the light is off, the reset is successful.
Why Jeep Patriot won't start after reset the oil change light?
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
How do you reset 2008 Honda Element service light?
How do you reset 2008 honda element service light?
How do you reset engine light in 2008 buick lucerne?
how do you reset check engine light in 2008 buick lucerne
How do reset t-belt light cruiser 2008?
Hi I have cruiser 2008 gxr how is reset t.belt light
Where is the oil filter located on a 2008 sequoia?
http://www.tundrasolutions.com/forums/tundra/104260-diy-oil-change-w-pics-reset/ the best site I have found.
How do you reset the oil change on 2008 ford escape?
To reset the oil change light on a 2008 Ford Escape, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. Afterward, turn the ignition off and then back on to ensure the oil change light has been reset. Check the instrument panel to confirm that the light is no longer illuminated.
How do you Reset Maintenance Warning Light on a 2008 Toyota 4Runner?
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
How do you reset a 2008 tundra tire pressure?
There is a button under the dash in front of your right knee
How do you reset low tire warning in 2008 tundra?
To reset the low tire warning in a 2008 Toyota Tundra, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "ON" position without starting the engine. Press and hold the tire pressure warning reset button, usually located under the steering wheel, until the warning light blinks three times, then release the button. Finally, start the engine, and the warning light should be off if the tire pressures are correct.
Tire pressure reset switch on a 2008 Toyota Tundra?
up under the dash by your right knee.
