open fuse box on inside of driver door at the top there is a red button while car is switched on not running press and hold button down for about 10 seconds this should reset it
I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner
To reset the "CHANGE OIL" light, turn the ignition switch to the "RUN" position with the engine off. Fully depress and release the accelerator pedal three times in five seconds. The light will flash twice and go out.
Have vehicle scanned to determine the problem
If you can't get to the back of the light through the trunk, you have to remove the light to change the bulb from the rear.
Refer to owners manual
You must have the special needed tool to reset the oil indicator light.
To reset the check engine light on a 2002 Alero, you can disconnect the battery for about 15 minutes, which will clear the error codes and turn off the light. Alternatively, you can use an OBD-II scanner to erase the codes if you have access to one. However, it's important to first diagnose and address any underlying issues causing the light to come on, as simply resetting it may not resolve the problem. Always ensure the vehicle is turned off before disconnecting the battery.
To reset the change oil light in a 2002 Yukon XL, first turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then turn off the ignition, and when you start the vehicle again, the oil change light should be reset. If it remains on, repeat the process to ensure it resets correctly.
vice & oil reset 2002 sl500
how do i reset timing belt light on 1hz
To reset the oil light in a 2002 Oldsmobile Bravada, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. This should reset the oil change light. Finally, turn off the ignition and restart the vehicle to ensure the light is no longer illuminated.
Once you have repaired the cause of the light, it will reset itself.Once you have repaired the cause of the light, it will reset itself.