With a scan too or with a battery disconnect.
i checked and found unplugged wires
you will go to the toyota dearler it good pleace
A Check Engine light can be reset by fixing the problem that caused it to go off. The codes that caused the light to go off can be cleared with an OBD II scanner.
Either reset with a scan tool, or by unhooking the battery.
After repairing the cause of the code, you can clear it with a scan tool.
Remove backup fuse from underhood fuse box
No
The 1993 Jeep Grand Cherokee engine control module is located on the firewall in the engine compartment. The engine control module will be on the passenger side of the firewall.
If same engine and transmission models, yes.
There are a few different ways to reset the check engine light on this vehicle. You can either have a mechanic use a scan tool, remove the battery cables and touch them together, or fix the problem to get the light to go off.
Have vehicle scanned to determine the problem - usually a problem in the emission control system
with the key lock and unlosk the front doors or the lift gate on the rear.