0
To reset the computer on a 2006 Pontiac Montana van, disconnect the negative battery cable and let it sit for about 15 minutes. This allows the system to clear any stored codes and reset the computer. Afterward, reconnect the negative battery cable and start the vehicle, which should reset the computer settings. If necessary, drive the van for a short while to allow the computer to recalibrate.
What else can I help you with?
Firing order for a Pontiac Montana?
fring order for 3.5 l Pontiac Montana 2006
How long does it take to replace 2006 Pontiac L Montana?
Depending with the experience and the expertise of the mechanic. it may take up to 1 hour to replace 2006 Pontiac L Montana.
How do you replace spark plugs on 2006 Pontiac Montana?
One at a time
What size is the 2006 Pontiac Montana rear wiper blade?
151,000
How do you reset the computer on 2006 Chevy Trailblazer?
How do you reset the computer in a 04 blazer 4.3L
Which fuses on 2006 Pontiac momtana for electrical power?
main electrical power fuses for 06 pontiac montana
How do you reset computer after a change of battery on 2006 Toyota sequoia?
You do not have to reset the computer. It will take care of itself.
Can you reset the driver information system on your 2006 Pontiac G6?
how do you reset the tire pressure monitor for the g6 2008
How do you change rear brakes on a 2006 Pontiac Montana?
Remove the 2006 Pontiac Montana wheel and tire. Remove the brake pad Springs. The brake pads will come off. Reverse the process to install the new brake pads.
How do you reset the computer on a Honda 2006 crv?
The on-board computer is factory installed and cannot be 'reset' - it must be replaced.
How long does it take to replace the motor 2006 Pontiac Montana v6 3.5 L?
The duration to replace the motor 2006 Pontiac Montana V6 3.5 L depends with the expertise and experience of the mechanic. IT may take at least 3 hours.
How do you change front turn signal on 2006 Pontiac Montana?
You can change the front turn signal, on your 2006 Pontiac Montana, by removing the retaining nuts. Remove the wiring harness. The turn signal will come free. Reverse the process to install the new turn signal.
