answersLogoWhite

0

What else can I help you with?

Related Questions

Which years r same body as 89 Chevy Beretta?

88 and 90


3.1 Chevy what type lifters on 90 beretta roller or flat HYDROLIC?

The 1990 will take flat hydraulic.


Where is the cooling fan relay for a 90 Chevy Beretta 2.1l?

It will be mounted up near the battery on the driver side inner fender.


Why does the oil pressure in a 90 Chevy Beretta drop to 0 when the engine warms up?

it may be the oil pressure sender located on the engine


Do you have a Picture of a fuse panel for a 90 Chevy beretta?

I can take a picture with my camera phone and send it to you in a text message if you have a camera phone. Go to a bookstore or a parts house and get a Haynes Manual.


How do you reset oil change indicator 90 Thunderbird SC?

i believe you need a computer that can hook up to the car for that, if not, check the manual


What would make a 90 Chevy beretta in park rev up and down and then die?

I had the same exact problem and i had 5 out of my 6 fuel injectors going bad so i would have them checked out if you havent already


How do you reset warning system on 1996 jeep?

´90-´90´90


How do you Reset dashboard warning lights on 90 Lexus ES250?

How do I Reset dashboard warning lights on 90 Lexus ES250


Is it hard to get exterior body parts for a 1989 Chevy beretta?

no not really. i just pulled a body kit from a 1990 beretta to fit on my 1995. during the 8 years beretta and corsica were around Chevy didn't really change the body styles all that much. so anything u find for a beretta, whether it would be a fender or a decklid, hood, you should have no problem getting it to fit, and parts aren't hard to find. just check with your local boneyard. the doors are the only body part that wont bolt up, pre 90 there are 2 door studs on the frame due to the seat belts being attached to the doors


How do you fix a broken tension pulley on a 90 Chevrolet Beretta?

There is no fixing it. It must be replaced.


How do you reset your check engine light?

DISCONNECT THE + BATTERY POST, THEN RECONNECT. THIS SHOULD RESET THE INTERNAL COMPUTER. IF ITS FOR INSPECTION PURPOSES THE ICPU WIL GIVE NOT READY CODES UNTILL DRIVEN AT LEAST 90-150 MILES.