Why would you need to reset the Powertrain control module (PCM)???
Are you asking how do you clear the CHECK ENGINE LIGHT??
Just reset your computer after replacing the O2 sensor.
It is possible as the signal from the oxygen sensor is sent to the computer
Your computer may need to reset, try disconnecting your battery for at least 30min.
P0133 Means the Bank1 Sensor 1 oxygen sensor is not communicating correctly with the computer, weather the sensor is failing, or there is an issue with the wire/connection from the main harness to the the sensor lead itself. usually replacing the oxygen sensor (this one is located just off the engine in the exhaust manifold) will resolve the issue.
Nope. The computer doesn't even look at the oxygen sensor until the oxygen sensor reaches operating temperature.
on the mufflers after the heads
Unfortunately there is no fixing an O2 sensor. If the "check engine" light is on due to an O2 sensor, it can only be remedied by replacing the bad sensor.
An oxygen sensor is a device that measures the oxygen in a car's exhaust. The computer uses this to adjust the amount and timing of fuel injected.
The computer uses the oxygen sensor reading from the exhaust to adjust the amount of fuel injected into the engine.
Not directly. The oxygen sensor measures oxygen levels in the exhaust. The computer uses that to calculate fuel and spark timing. If an oxygen sensor is malfunctioning, it could cause idle problems.Not directly. The oxygen sensor measures oxygen levels in the exhaust. The computer uses that to calculate fuel and spark timing. If an oxygen sensor is malfunctioning, it could cause idle problems.
You can replace the oxygen sensor on a 2002 lincoln LS by first unplugging the old one and then making sure the tread marks are lined up replace it with the new one.
No, you do not as the computer does it, provided you install the correct one.