fix the problem first or it will just come back on, usually a bad front wheel sensor.
To reset the check engine light on a 2003 Chevy Impala, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the engine control module's memory. Alternatively, you can use an OBD-II scanner to read and clear the trouble codes, which will also turn off the check engine light. Keep in mind that if the underlying issue isn't resolved, the light may come back on.
The abs light is on because you have a problem with the abs system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself.
Type your answer here... Hello how do you reset the check engine light on a 2003 Toyota 4runner. Thanks
To reset a check engine light for a Highlander 2003, disconnect the battery for 10 minutes. After this time, reconnect the cables.
turn the parking lights on and off 3 times
There is not a reset switch.
There is not a reset switch.jd
disconnect your battery and then reconnect. The light should reset and turn off.
The check engine light is reset with a scan tool after repairing the failure that caused the trouble codes.
If you fix the reason the light came on in the first place the check engine light will reset itself after a few drive cycles.
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
Listed in detail in your owner's manual. Don't have one then you need to get one.