1. Using the NGS scan tool and Service Card, select Service Bay Functions.
2. Select PATS.
3. Select Enter Security Access (this will require a 10 minute delay).
4. Select Parameter reset (do NOT perform any other selections at this point).
5. Turn the ignition switch OFF and disconnect the scan tool from the On-Board Diagnostics II (OBD2) connector.
6. Cycle the ignition switch from the OFF to the RUN position 5 times. Each time the key is cycled, leave the key in the RUN position for at least 3 seconds and leave the key in the OFF position for at least 2 seconds.
7. After the 5th cycle of the key to the RUN position, the theft light should perform a normal prove-out and the engine should start.
To reset the anti-theft system on a 1998 Mercury Sable, first, ensure the vehicle is off. Insert the key into the ignition and turn it to the "On" position without starting the engine, and leave it there for about 10 minutes until the anti-theft light turns off. Then, turn the key back to the "Off" position, wait a few seconds, and try starting the vehicle. If the system does not reset, consult the vehicle's manual or a professional for further assistance.
where is the anti theft located on a 2000 mercury cougar
Reset anti theft system
You will need to take it to the dealer. They are the only way to reset the anti theft.
how do you reset the anti-theft system on a 1999 Ford windstar
how do u reset the anti theft system on a 1989 cadillac eldorado
how do you reset the anti-theft system on a 1999 Ford windstar
how do you reset the anti-theft system on a 1999 ford windstar
how do you reset the anti-theft system on a 1999 Ford windstar
how do you reset the anti theft system in a ford 2001 mustang
How do rest anti theft
How do i reset my anti-theft system in my 1997 nissan altima se?