To reset the codes on a 2008 Saturn Vue, you'll need to disconnect the vehicle's battery. Start by turning off the ignition and removing the negative battery cable; leave it disconnected for about 15 minutes. This will clear the codes from the car’s computer. Reconnect the battery, and the codes should be reset. If the check engine light reappears, further diagnostics may be necessary.
how can I reset the security system on my 06 saturn vue
How do you replace the side marker lights on a 2008 saturn vue?, they seem to be hid completely in the body.
Nothing to reset except the radio presets and the clock.
To reset your 2007 Saturn Vue after changing the battery, you may need to reset the clock and radio presets. Additionally, to clear any error codes, you can disconnect the battery again for a few minutes and then reconnect it. If the check engine light is on, you might need an OBD-II scanner to reset it. Finally, drive the vehicle for a short distance to allow the engine control module to recalibrate.
On a 2008 Saturn Vue , you don't mention the engine size , but the 2.4 liter four cylinder uses a timing CHAIN ( also the V6 )
Most any code reader that plugs into diagnostic port can reset
My vue needed a gas pedal. which is just another (expensive) switch.
Well, when you've finished changing the coolant on your 2006 Saturn Vue and you notice the light is still on, don't worry, it just needs a little reset. Simply locate the fuse box under the hood, find the fuse labeled "ECM" or "ECU," remove it for about 30 seconds, then put it back in. This should reset the light and your Saturn Vue will be back to shining bright in no time.
Saturn Vue was created in 2002.
I had my compass go wacky on my 2004 saturn vue there is a procedure in the owners manual it involves pressing the button on the mirror and driving slowly in a circle yes this is true check your manual
To reset the tire pressure sensor on a 2008 Saturn Vue, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "On" position without starting the engine. Press and hold the tire pressure monitoring system (TPMS) reset button, usually located under the dashboard or near the steering column, until the TPMS light blinks and then turns off. Finally, start the engine and drive for a few minutes to allow the system to recalibrate.
It is Lil King Kong by Simple Kid