0
At the bottom of the instrument cluster bezel there are 2 rectangular plastic closeout "plugs". Carefully pry off the one on the right side off and look inside (may need flashlight). There is a switch with a sliding black button about 2 inches deep below where the closeout "plug" was. Slide the switch over to the other side and you should be done. Replace plug. Finished.
What else can I help you with?
How do you reset the Egr light on a 1987 B2200?
The EGR warning light will illuminate after the first 60,000 miles. This indicates that the ignition timing should be checked and adjusted as necessary and that the O2 sensor, EGR control valve, hose and tube and the PCV valve should be inspected and repaired or replaced as necessary. After the adjustments or repairs are made, reset light by disconnecting ground connector from combination meter,Fig. 2, wrapping connector with tape to prevent shorting, starting engine and ensuring light does not illuminate.
How do you locate and replace the EGR valve and then reset the check engine light on a 2000 Ford Mustang?
I don't know much about the EGR valve yet....but i know some autoparts stores can reset your light for free...just call around.
Where is the egr valve on a 2001 dodge ram 5.2?
A 2001 Dodge Ram does not have EGR.A 2001 Dodge Ram does not have EGR.
What is the EGR light mean on an 87 suburu wagon?
The EGR (Exhaust Gas Recirculation) light is alerting you to inspect and service the EGR system. The light is triggered by the odometer, not the system, so after it is checked and serviced, you'll need to reset it under the dash board.
Reset check engine?
check engine light reset on a 1999 Acura CL 3.0.. Just replaced the egr valve. Thx
Why does check engine light stay on after replacing the egr valve on a 2001 buick lesabre?
Because you did not have a faulty EGR valve. You misdiagnosed the problem. Start over and remember the code only tells you what part is being effected not necessarily the defective part. This is assuming you reset the light or drove the car enough cycles for the light to reset. If not then reset the light and see if it comes back on.
Replaced the EGR valve in my 2000 Honda odyssey...is there a way to reset the check engine light?
You can reset it with your OBD reader or you can disconnect the negative battery cable for a couple of minutes to reset the check engine light.
How do you reset check engine light after replacing egr valve?
Try removing negative battery cable for 10 minutes. If that does not work you will need an OBD2 scan tool to reset the light. I just cleaned my egr valve and the check engine light went off and I drove it a little and it came back on how long do I have to drive my car after work with the egr valve how many miles
Where is the EGR valve on 2001 Dodge Dakota?
It does not have EGR.It does not have EGR.
How to replace egr valve in 98 dodge 1500?
A 1998 Dodge Ram does not have EGR.
How do you change a 2006 dodge diesel egr valve?
The Cummins in a Dodge truck did not get EGR until 2007 with the 6.7L.The Cummins in a Dodge truck did not get EGR until 2007 with the 6.7L.
How do you reset after having replaced the part the egr dashboard light from your 1987 mitsu mighty max pickup?
Most are located behind the gauge cluster. You have to remove the trim and four screws to get to the little switch either by the spedo cable or lower right corner of the cluster. ( if this a 120,000 mile interval, remove the light!) REMOVE TRIM COVER FROM RIGHT LOWER DASH, YOU WILL SEE A SMALL SWITCH. USING A LONG SCREWDRIVER YOU CAN MOVE SWITCH AND RESET EGR LIGHT.
