0
the factory defalt setting cannot be chandged and will always work, even though you add an additional code of you preference. here are the steps. # Enter the permanent factory remote keyless (RKE) keypad code # Press the 1/2 button within 5 seconds to activate the programming mode # Holding the 1/2 button for more than 2 seconds after activation erases the stored personal code # Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed. Entering any new personal code automatically erases the old personal code
What else can I help you with?
What is fuse24 on a 1998 Ford Econoline E150 used for?
That is the Illuminated Entry Module, 5 amp
Location of keyless entry module for 1998 Honda Accord?
The keyless entry module on a1998 Honda Accord is located underneath the dashboard. It is housed on the driver-side the of dash close to the main relay.
Location of the keyless entry module in 98 Saturn?
The location of the remote keyless entry module on a 1998 Saturn is in the rear of the passenger compartment. It is underneath the trim at about shoulder height by the right rear seat.
How do you reset the check engine light on a 1998 ford contour?
Easy, fix the problem that caused the light to come on in the first place.
Do a 1998 ford contour svt has a reset for the fuel pump?
Yes , in the drivers footwell , behind the kick panel ( there is an access hole )
How do you install a radiator in a 1998 Ford Contour?
How do you install a radiator in a 1998 ford contour?"
Where is the RKE Remote Keyless Entry module located on a 1998 Chevy Corvette?
== ==
How do you program a new key for a 1998 ford contour?
The keys on the 1998 Ford Contour are NOT chipped
Where is egr valve 1998 2.0 contour located?
where is egr valve on 1998 ford contour
1998 Ford Contour Why would a radio and clock reset itself while going down the road?
Loose power or ground wire connection.
How do you reset the alarm on a 1998 Chrysler Sebring?
To reset the alarm on a 1998 Chrysler Sebring, you will typically need to locate the alarm system's control module. This module is often found under the driver's side dashboard or near the fuse box. Once you locate the control module, you may need to disconnect the battery for a few minutes to reset the alarm system. Reconnect the battery, and the alarm should be reset. If this does not work, consult the vehicle's manual or a professional mechanic for further assistance.
1998 Ford contour What is the main power supply?
The battery is the main power supply of the 1998 Ford contour.
