answersLogoWhite

0

open fuse box on the driver's side (just pull the door off the fuse box)

find the red button that says "reset" press it, the Check Oil light should come on. press it again. the Check Tire Pressure light should come on. now, press and hold the reset button. the tire pressure is now reset and you can put the fuse box door back on.

for best results, drive normally at various speeds to "re-teach" the tire pressure monitor the correct tire pressure.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you reset tire pressure warning light on the dashboard for 2000 Oldsmobile alero?

My tire pressure light has been on forever. I finally got it to go off by holding in the reset button til it blinked and then shut off. You can try that.. if not it's just gonna stay on.


How do you reset the low tire pressure light on a 2000 alero?

If you open the driver door, on the side of the dash you should see a small removable plastic plate. Pull it off with your finger and inside is a small red reset button, somewhat in the middle. Push it once the oil light should flash, push it again the tire pressure light will flash. Push and hold and it will reset! :) Hope this helps!


How do you reset the traction control on a 2000 olds alero?

you cant bad speed senser in one of the wheel bearings is abs light on?


How do you reset the check tire pressure light on Buick Le Sabre 2000?

Press the reset button for about 5 secs while viewing the tire pressure.


How do you reset the change oil light on a 2000 Alero?

On the left side of the drv'r door you will see a fuse panel. open it, turn the ignition to on position, pres the reset button once, the light will start flashing, press and hold the reset button till the light goes out. Note also works for the tire pressure light. Also if you have been trying other methods, you can reset the codes by disconnecting the negative battery cable then connecting it. Then use the above method. It is in the owners manual


How do you reset oil pressure light on 2000 vw jetta?

The oil pressure light will reset on it's own when your oil pressure is good. As long as it is lit you oil pressure is too low and you should stop running the engine as soon as safely possible.


How do you reset the low tire pressure light on a 2000 Oldsmobile Alero?

Turn your ignition switch to 'ON' (don't start the car) The reset button is on the driver's side instrument panel, this is also where your fuses are located. Press the recent button once and your 'Change Oil' light should start to flash. Press the reset button again and your 'Low Tire Pressure Light should start to flash. Press and hold the reset button until you hear a few chimes and then let go.(wait tell the light shuts off then let go) Your light should then be off. To get to the fuse box, you must have the drivers door open. Pull on the plastic piece and the reset button is there.


Reset abs light 2000 Yukon?

how to reset abs warning light on 2000 gmc Yukon


How do you reset the low tire pressure light in a 2005 Monte Carlo LT?

In a 2000 to reset the low tire pressure light, first make sure the tires are properly inflated and then to reset the light pull the head light switch from off to parking lights and back to off 3 times. Otherwise it will say it your owners manual.


How can you reset the service vehicle soon trac off and anti lock lights on 2001 alero?

On my 2000 Alero I open drivers door and open fuse panel door. Then turn key onposition but don't turn engine over. Push in reset button until the light you want flashes then hold the reset button for a few seconds.


How do you reset the change engine oil light on a 2000 BMW 528i?

try to reset oil light on 528i bmw year 2000


How do you reset the ABS light on a 2000 Mazda 626?

You can reset the ABS light in a 2000 Mazda 626 by unplugging the battery cables. You can also reset it by connecting a diagnostic tool to your car.