0
What else can I help you with?
How do i change an alternator on a 1992 Corvette?
very carfully
How do you reset oil change light on 1992 BMW 118i?
To reset the oil change light on a 1992 BMW 118i, turn the ignition key to the "on" position without starting the engine. Press the gas pedal three times within five seconds, which should trigger the reset. Finally, turn off the ignition and then start the engine to ensure the oil change light is no longer illuminated. If the light persists, repeat the process.
Where is the courtesy light delay on my 1992 corvette?
The courtesy lightsÊon your 1992 Corvette is on the bottom side of the rear-view mirror. However, there is no light delay switch as the lights can easily be turned on or off.Ê
What do you check when the Inflatable Restraint light stays on in the dash of a 1992 corvette?
== ==
How do you reset computer 1992 Corvette?
Sometimes the computer of a car can become messed up. To reset a computer, one must find a car dealership that has the device to reset the computer.
What is the reset procedure for a 1992 Corvette after changing batteries?
Computer should restore all the settings after driving for a while.
How do you reset oil change light on 1992 olds 98?
press the oil button then press the reset button hold for five seconds it will reset oil life monitor back to 100%
How do you reset maint reqd light on 1992 Plymouth voyager?
The maintenance required light requires a scan tool to be reset.
Abs light reset 92 Chevy lumina?
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
Where is the fuse that controls the antenna to a 1992 Corvette?
where is the fuse that controls the antenna to a 1992 corvette?
Why does your 1992 Corvette convertible not have a third brake light or Corvette lettering on rear bumper?
Sounds like it may have been replaced at one point with an inferior piece.
How do you turn off the 'change oil' light in a 1992 Chevrolet Corvette Lt-1?
also try to change the oil. Try disconnecting the batery for 15 minutes. The computer will reset itself. This worked on a '95 Thunderbird. To reset the oil light, put the key in the ignition and turn to accessory setting (but do not start the car) Push the English/Metric button twice and then push and hold the "Gauges" button. The "Change Oil" light will flash for about 15-20 seconds and then go out. Release the button and turn key off. When you turn the key back on, the light should be out. If it is not, repeat the above steps. Try changing the freaking oil!!!!!!!! That might help!!! I'm just saying!!!!!
