answersLogoWhite

0

Should reset itself when fluid is added unless sensor is bad

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you reset the low washer fluid light on 2004 Alero?

You don't. Just and fluid and it will go off.


How do you reset the low windshield fluid light in 2013 dodge ram?

There is no reset. Either the fluid is low, or there is a level sensor malfunction.


How do you reset the change oil light in 2004 alero?

how do you reset change the oil light in a 2004 alero?


How do you reset the low windshield washer fluid light in a 2001 Tahoe when its full?

Should reset when fluid added--may be defective sensor in reservoir


How do you reset the low windshield indicator in a 2001 Corvette?

Assuming you mean the low windshield washer fluid indicator, by just filling the reservoir with windshield washer fluid, the light should turn off. If not, the low washer fluid sensor may be faulty.


What does the low coolant warning display light look like on a 2001 alero?

I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner


How do you reset the low windshield washer fluid light in 2003 Saturn L200?

If the sensor is functioning properly, when you add the washer fluid the light should turn off automatically; no additional action required.


How do you turn the low wind shield fluid light off?

To turn off the low windshield fluid light, first, you need to fill the windshield washer fluid reservoir with the appropriate fluid. After refilling, the light may turn off automatically once the system detects the fluid level is adequate. If it doesn’t, try turning off and restarting the vehicle, as this can sometimes reset the warning light. If the light remains on despite a full reservoir, there may be an issue with the sensor or electrical system.


How do you make 2006 vw jetta windshield wiper fluid warning light turn off after filling reservoir?

You have to push the reset button where your mph gauge is.


How do you reset the windshield washer fluid warning on a 2009 Dodge Journey?

To reset the windshield washer fluid warning on a 2009 Dodge Journey, first, ensure the washer fluid reservoir is filled to the proper level. Then, turn the ignition to the "ON" position without starting the engine. Press and hold the trip odometer reset button until the warning light goes off, which may take a few seconds. Finally, turn off the ignition and then restart the vehicle to confirm the reset is successful.


How do you Reset ABS light for a 2001 alero?

you may have a bad front wheel bearing hub assembly. 55 dollars for aftermarket. e z to replace. check brake fluid level too.


How do you reset the service engine light on a 1999 Oldsmobile Alero?

turn off engine, and start again