0
To set the clock on a 1988 Chrysler LeBaron you start by pressing the "set" button while the radio is on and push the volume knob in. Once you see the hour number flashing on the screen, adjust by using "seek" and press the volume knob in once you set the hour and then it will go to minutes. Adjust the minutes using the same "seek" button and press the volume knob in and the time will be set.
What else can I help you with?
How do you set clock on a 1993 Chrysler Lebaron?
Turn the radio on and press sel twice for hours and once for mins
How do you set the clock in a 2007 Chrysler 300?
You will need both hands to set the clock in the 2007 Chrysler 300. Hold the power button in and adjusts the time with the tuning knob.
How do you set the clock on 1998 Chrysler fifth avenue?
There is no such thing as a 1998 Chrysler Fifth Avenue
How do you set the clock on a 1998 Chrysler fifth avenue?
There is no such thing as a 1998 Chrysler Fifth Avenue
Is there anything you need to do after you change the battery in a Chrysler new yorker?
Set the clock and radio presets.Set the clock and radio presets.
Why is your 1991 Chrysler lebaron 604 trans in limp mode?
The transmission computer has detected a malfunction and set a code.
How do you set the clock on a 1986 Chrysler Fifth Avenue?
turn on the radio on press set then press the power button the hour or minutes will flash turn other knob to adjust when done press (3rd time) clock is set
94 Chrysler lebaron set timing and replaced water pump and now it wont start why?
did you make sure the #1 piston was top dead center and that when you set your timing that the springs where without tension? if not its out of time
Do you set the clock on a 1993 Chrysler 5th ave the same way as on the 1988?
It's very easy.....there are two buttons on the right middle of radio....labled H(hour) and M(minute) simply push those buttons to adjust time..
Why does your 1994 Chrysler Lebaron downshift when you drive over a bump?
the car probably senses that it slowed down or is set to shift at large bumps if it is an automatic and if it is a manual it might be a bad clutch
How do you set the clock in a 1988 Chrysler Fifth Avenue?
Turn on the radio, then press the set button, followed by the volume button. Once the hours are displayed adjust the hours by using the tuning dial to correct hour. Press the volume button again to adjust the minutes. When finished, press the volume button again to complete the set up.
How do you set the quartz clock in your Chrysler 200 Not in owners manual I changed the clock on your radio but this is a clock above your radio?
To set the analog clock, located at the top center of the instrument panel, press and hold the button (located just to the left of the clock on the silver bezel, at the "nine" o'clock position) in until the setting is correct. The clock will adjust slowly at first and then quicker the longer the button is held.
