answersLogoWhite

0

disconect the battery and wait nearby until the actual time is the same as what the van clock is. be advised, this will be a life altering experiance.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Why doesn't 1995 Chevy Astro van start when it rains?

When was the last time the ign. wires were changed?


How do you reinstall a distributor on a 1998 Chevy Astro van?

how reinstall a distributor on a 1998 chevy astro, and faun time


How do you set the clock on a 1995 Chevy Blazer S-10 with Delco CD radio?

hold in the "clock" button until the time comes up then turn use the volume and channel controls to adjust.


How do you set the clock time on a 2003 astro van?

Press and hold the set button until the clock appears, then adjust the time using the scan buttons.


How do you set the clock time on a 1997 Chevy Astro van?

Using the minute and hour buttons at the bottom right of the radio. (4.3L Auto) Using the minute and hour buttons at the bottom right of the radio. (4.3L Auto)


How do you set the clock in a Mercedes c220?

How do I set the time on the clock on a 1995 Mercedes C220


How do you change the clock on a 1998 Chevy Astro Van?

With the key in the "on" position, but the radio off, press the "set" button, then press the scan buttons to change the hour and minutes. When the correct time is reached, press the set button again.


How do you set the clock on your astro van?

To set the clock on your Astro van, first locate the clock display on the dashboard. Turn the ignition to the "On" position without starting the engine. Then, press and hold the "HR" button to set the hour and the "MIN" button to set the minutes until the correct time is displayed. Release the buttons to save the settings.


How do you change the time in a 2007 Chevy Equinox?

How do you set the clock in 2007 equinox..Take it off military time


How do you set clock on 1995 magic chef microwave?

To set the clock on a 1995 Magic Chef microwave, first press the "Clock" button. Then, enter the time using the number keypad, ensuring to specify AM or PM if applicable. Finally, press the "Clock" button again to confirm the setting. The display should now show the correct time.


How do you set clock on 1985 Chevy K10 Truck radio?

To set the clock on a 1985 Chevy K10 truck radio, first, locate the "Clock" or "Time" button on the radio. Press and hold this button until the time display starts blinking. Use the "Tune" or "Seek" buttons to adjust the hours and minutes. Once you’ve set the correct time, press the "Clock" button again to save the settings.


Why does my 1995 Chevy van have reverse but no forward?

Time for a transmission rebuild.

Trending Questions
What is the Original rim size for grand marquis 1998? When turning right and pressing the brake you have a squeek What could this be? On a 2003 Pontiac Montana the rear brake lights don't work and the bulbs are not burned out? How do turn on the rear sonar? Why does your check air ride come on as soon as you start a 96 mark viii? Where is the thermostat on a 2000 3.4 Chevy Impala? Where is spark plugs on 1999 tracker? What could cause the brake lights to stop working on a 1992 Camaro RS if the bulbs and fuse check out ok? What causes a 97 Buick Le Sabre to have a strange shake when accelerating but goes away when you let off the gas? How many gallons does the gas tank in the 2001 Chevrolet Corvette hold? How do you remove the strong smell of the leather in the car seat? What is the maximum cargo capacity of the 2011 GMC Yukon-Hybrid? Where is the best place to install water temp gauge on a small block Chevy? Antenna motor on 1990 caprice classic still running with car off why? Where is the fuel pump reset switch on a 2003 Lincoln Town Car? 1996 Firebird and the lighting for the instrument cluster went out How do you find and correct this problem? Where are the lift-jacking points on a 2003 ford Windstar? How do you reset the check engine light on a 1989 Pontiac sunbird le? How do you fill the transmission fluid on a Saturn sc1 1999? How much it costs to replace a vacuum cutoff valve and vacuum cutoff bypass valve for a 2000 Nissan sentra as iam getting a ses light the error code is p1491?