answersLogoWhite

0

The VIN number should have an indicator. VIN number references can be found online or in the repair manual for your car.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the fuse box on the 99 Mercury Sable?

On a 1999 Mercury Sable : The fuse box is below and to the left of the steering wheel , by the brake pedal ( it has a cover on it ) * Also , the Power Distribution Box ( which is " live " ) is located at the front of the engine compartment , near the battery


What will happen if the thermostat is installed backwards in your 99 Mercury Sable?

The thermostat will not open properly when installed backwards. The coolant will not flow and the engine could overheat.


What is fuse 17 on 99 Mercury Sable?

On a 1999 Mercury Sable : In the fuse panel by the brake pedal : ( # 17 is a 30 amp fuse for the front wiper / washer )


Will the radiator on a 1995 Ford Taurus work for a 1995 mercury sable?

99% sure the Taurus radiator will be a perfect match to the Sable's.


Will a door off a 97 Ford Taurus fit a 99 mercury sable?

yes


How many gallon gas tank does a 99 mercury sable wagon have?

16.0 gallons


What engine oil for 99 Mercury Sable gs u series?

According to the 1999 Mercury Sable Owner Guide : 5W-30 engine oil is used in the 3.0 liter " Vulcan " V6 engine ( and also the 3.0 liter " Duratec " V6 engine ) * With engine oil filter change , the 3.0 liter " Vulcan " V6 engine takes 4.5 U.S. quarts / 4.25 liters of 5W-30


What kind of motor oil for 99 mercury sable?

According to the 1999 Mercury Sable Owner Guide ( 5W-30 ) With engine oil filter change : The 3.0 " Vulcan " V6 engine takes ( 4.25 litres / 4.5 U.S. quarts of 5W-30 ) The 3.0 " Duratec " V6 engine takes ( 5.2 litres / 5.5 U.S. quarts of 5W-30 )


How long does it take to change a master brake cylinder on 99 Mercury Sable?

21 hours


Where is the 1999 Mercury Sable 12 volt auxiliary power outlet location?

how do I get to the plug at the back of the power outlet/ ash tray 99 sable


Where is the knock sensor in 99 Mercury sable?

In a 1999 Mercury Sable, the knock sensor is typically located on the engine block, near the intake manifold. It is usually positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to the vehicle's service manual for exact locations and procedures.


The parking lights and dash lights are out on your '99 Mercury Sable where can you get a wiring diagram for this?

Start with the headlamp switch.