If it has excessive wear in the rack & pinion then rebuilding or replacement may be necessary.
On a 1991 Oldsmobile Cutlass Calais, the turn signal flasher is typically located under the dashboard, near the steering column. It is often found in the fuse box or attached to the steering column itself. To access it, you may need to remove a panel or cover under the dashboard. Always refer to the vehicle’s service manual for specific instructions and locations.
You can have your steering column tighten for approximately $75. The cost is dependent upon the hourly rate of the mechanic.
To replace the ignition switch on a 1989 Oldsmobile Cutlass Calais, first disconnect the negative battery cable to avoid electrical issues. Remove the steering column cover by unscrewing the screws, then locate the ignition switch attached to the steering column. Disconnect the wiring harness from the old switch and remove it by unscrewing the mounting screws. Install the new ignition switch by reversing the steps, ensuring everything is securely reconnected before reassembling the steering column cover and reconnecting the battery.
Dont
Steering column
You have to replace the entire steering column. It is not loose, the lock is broken on your column height adjuster.
how do i tighten the steering column on a 89 buick park avenue electra
How long does it take to remove a steering column on a 1989 Cadillac Deville
Take it to the shop:)
To tighten the steering column on a 1988 Buick Park Avenue, first, ensure the vehicle is turned off and the key is removed. Remove any necessary panels to access the steering column's mounting bolts. Use a wrench to tighten the bolts securely, ensuring the column is properly aligned. Reassemble any panels you removed, and check for any play in the steering to confirm it’s properly tightened.
Along the right side on the steering column.
under the steering column above the brake pedal