There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light
Dome light fuse for 2004 Bravada is fuse#4 (10amp) in fuse box underneath back seat on driver's side
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
To reset the oil light in a 2002 Oldsmobile Bravada, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. This should reset the oil change light. Finally, turn off the ignition and restart the vehicle to ensure the light is no longer illuminated.
To replace the license plate bulbs on a 1998 Oldsmobile Bravada, first, open the rear hatch and locate the license plate light assembly. Use a flat-head screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise until secure. Finally, snap the lens cover back into place and test the lights to ensure they are working.
The light is built into the bumper on that car. Just above the plate.
Most offen its the encoder motor it is a electric motor the engauges the All wheel drive its located to the passager side of the transfer case and can be bought from auto parts store for around 170.00$ Thanks James
Same circuit/fuse as the parking/tail lights.
open hood two pins with rubber caps hold lights in. pull them up and out light will then fall out change bulbs and reinstert pins
In an Oldsmobile Aurora, the fuse for the license plate light is typically located in the fuse box, which is usually found under the dashboard on the driver's side or in the engine compartment. Refer to the owner's manual for the exact location and designation of the fuse, as it may vary by model year. If the license plate light is not functioning, check the fuse for continuity and replace it if necessary.
You can disconnect the negative battery cable, wait a couple minutes then reconnect the cable. This will clear the codes and reset the check engine light but, if the reason the light came on isn't fixed the light will come back on soon.
most of the time, the bulb socket just comes out the back of the fog lamp. look on the inside of the front bumper for them. Should be easy.
remove the lowest panel on the dash ( the one under the steering wheel) the relays are under the radio there are 2 one for the blinkers and one for the emergency light.