0
What else can I help you with?
How do you check the check engine light on a 2000 Oldsmobile intrigue?
With a scan tool.
Why would check engine light blink on my Oldsmobile cutlass?
Probably because you need to check the engine.
How do you reset check engine oil light on a 2002 Oldsmobile Bravada?
I just had an oil change and the guy turned the key on (did not start car). Pumped the gas pedal three times simultaneous. Repeated with key off.
Were is the reset button for the check engine light for a 2000 Olds Bravada?
The light is reset with a scan tool after the repair. There is not a button.
Why does check engine light come on and auto stalls this is a 1994 Oldsmobile royal?
Use a code reader to find out why the check engine light is on.
How do you reset the oil light in an Oldsmobile bravada 2002?
To reset the oil light in a 2002 Oldsmobile Bravada, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. This should reset the oil change light. Finally, turn off the ignition and restart the vehicle to ensure the light is no longer illuminated.
When the check engine light comes on what could be the problem on a 1994 Oldsmobile royal 88?
If the check engine light is on, use a code scanner to find out why.
The check engine light is on my 199 Oldsmobile intrique?
take it to autozone and have it scanned
How do you clear the check engine light on a 1998 bravada?
After repairing the cause of the code, you clear the code with a scan tool.
Where is fuse for dome light on 1997 Oldsmobile Bravada?
Dome light fuse for 2004 Bravada is fuse#4 (10amp) in fuse box underneath back seat on driver's side
What does it mean when the check engine light is on in Oldsmobile delta 88?
The engine computer has detected a malfunction and set a code.
How do reset the ignition timing for a Oldsmobile bravada 4.3 liter?
To reset the ignition timing on a 4.3-liter Oldsmobile Bravada, first ensure the engine is at operating temperature and then turn it off. Disconnect the timing connector, usually located near the distributor, to enable the timing adjustment. Start the engine and use a timing light to check the timing mark on the harmonic balancer against the timing tab. Adjust the distributor until the timing is set to the specified value, usually around 0 degrees BTDC for this engine, then reconnect the timing connector and turn off the engine.
