You can disconnect the battery for about 5 minutes and this will clear the check engine codes stored in the computer. If the problem that caused the code has not been repaired the check engine code will just happen again. The only way to get the check engine light to not be on is to repair the problem then clear the codes.
it means you need to connect it to an odb 2 computer and get the code for whats wrong
The service engine or check engine light can be reset with a scan tool or by unhooking the battery. The light will return if the failure that caused the code is not repaired.
Need to know what the question is.
It is none adjustable, The idle or RPM's are controled by the computor. Is the check engine light on ???? If so, Then scan engine with a engine scanner and see what the problem is.
To turn off a service engine light soon on a 1997 Malibu, you will need to unhook the battery for up to 2 minutes. After you hook the battery back up, the light should be off.
Have it checked for codes, That is the same as the check engine light.
the starter on a 1997 Suburban is on the side of the engine. It is at the rear where the transmission meets the engine.
That is a 350 engine.
big 12
If the service engine soon light is flashing on the 1997 Geo Tracker, you might have a sensor that has been activated because your vehicle is due to be serviced. You could also have a sensor that is malfunctioning.
The fuel test port on a 1997 Suburban is on the engine under the hood. It is located near the fuel lines.
To reset the service engine light on a 1997 Suzuki Sidekick first turn off the car. Unplug the battery of at least 5 seconds and then plug the battery. The computer will now be reset.