answersLogoWhite

0

If all tires are inflated to 36 psi and the light is still on, you have a sensor issue and will have to take in for service. The dealer has a special tool that can communicate with each sensor (one in each tire) to find the bad one.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?


What does 2005 Chrysler 300 diagnostic code p0520 mean?

Engine oil pressure sensor circuit malfunction.


What does service tire system soon mean in a 2005 Chrysler pacifica?

Low tire pressure or failed tire pressure sensor.Low tire pressure or failed tire pressure sensor.


Will a bad oil sending unit on a 2005 Chrysler pt cruiser cause engine not to start?

No. The oil pressure sensor is not required for the engine to run.


Where is the mass air sensor on a 2005 Chrysler pacifica?

It doesn't have a mass air flow sensor.


Where is the mass air flow sensor on a 2005 Chrysler 300 2.7 v6?

It does not have a maf sensor.


Where is the cam position sensor located on a 2005 Chrysler Town and Country?

The cam sensor on a 2005 Chrysler Town and Country is on the passenger side top of the engine next to where the motor mount bracket attaches.


Where is the headlight sensor in the Chrysler 300 2005?

In the 2005 Chrysler 300, the headlight sensor, also known as the ambient light sensor, is typically located on the dashboard near the windshield, often near the rearview mirror. It may be integrated into the overhead console or the trim near the driver's side. This sensor detects ambient light levels to automatically adjust the vehicle's headlights. If you're having trouble finding it, consulting the vehicle's service manual can provide detailed guidance.


What will cause the overdrive light to flash on 2005 Ford Expedition?

The overdrive light to flash on 2005 Ford Expedition is caused by either the sensor problem or the electronic pressure control problem for the tranny.


Where is the the oil pressure switch on a 2005 Chrysler Sebring 2.7l?

The oil pressure sensor is on the back side of the engine. It is above the oil pan, behind a heat shield.The oil pressure sensor is on the back side of the engine. It is above the oil pan, behind a heat shield.


What would cause bad gas mileage in a 2005 Chrysler Sebring 2.7?

Sensor failure, would have check engine light on. Excessive idle time. Aggressive driving. Poor maintenance, spark plugs, air filter, etc. Low tire pressure.


Where is the crankshaft sensor on a 2005 Chrysler Town and Country?

The crank sensor is mounted on the top rear of the transmission bell housing.