If its the maintanence reminder, hold the trip odometer reset button and turn the ignition on. After about 10 seconds it will stop flashing or go off. If its the SES light, then you need a scantool
Usually there is a knob that clicks when you turn it, as you turn it the light will go on and off.
To operate a light switch, you simply flip the switch up to turn the light on and flip it down to turn the light off.
well most people say turn off the light but you could say switch of the light.
How does vsc light turn off on 2005 highlander?
the light comes on to tell you of a problem there are codes that indicate a problem you need a scan tool to find the part involved and a diagnostic procedure to determine the repairs needed
cause you have to turn it off
To turn off the check engine light after repairs, you can use an OBD-II scanner to clear the diagnostic trouble codes from the vehicle's computer. Alternatively, disconnecting the car battery for a few minutes can reset the system and turn off the light. However, it's essential to ensure that the underlying issue has been resolved, as the light will reappear if the problem persists. Always consult your vehicle's manual for specific instructions related to your make and model.
Turn Off the Light was created on 2001-08-14.
The light is on because there is a problem with the SRS. Have it repaired by a pro, and he will turn off the light.
You would have to pull courtesy light fuse, if they are to be open for extended period for repairs, just disconnect batt
It means the traction control system is on and that your car will less likely spin out or over rev for regular driving leave the system on so it means the light will not be there