To unbolt the headlight housing on a 1994 Chrysler New Yorker, you will first need to locate the bolts securing the housing in place. These bolts are typically located around the perimeter of the housing. You will need the appropriate socket wrench or screwdriver to loosen and remove these bolts. Once the bolts are removed, you can carefully pull the headlight housing away from the vehicle to access the headlight bulb or perform any necessary maintenance.
If you just want to change the bulb,you might be able to reach your hand behind the headlight and twist the locking ring counterclockwise and remove the bulb.you may need to unbolt the headlight housing to make room to replace it.
To remove a headlight from a 1995 Chrysler New Yorker, first, open the hood and locate the headlight assembly. Remove the screws or bolts securing the assembly, which are typically found on the top and side. Disconnect the electrical connector by pressing the release tab and gently pulling it away. Finally, carefully pull the headlight assembly out of the housing to complete the removal.
It is inside the HVAC housing, under the dash.
It is on the passenger side of the transmission bell housing.
There is a relay box just behind the battery ...
It is inside the HVAC housing behind the glove box.
It is on the passenger side of the transmission bell housing.
below thermostat housing little to left
It is inside the HVAC housing, behind the glove box.
It is under the housing where the upper radiator hose attaches to the engine.
It is under the housing where the upper radiator hose hooks to the engine.
For each headlamp, Remove the two 15mm Bolts that have a six pointed star in the middle of the head. The glass headlamp will then slide forward and you can reach behind and remove the lamp unit.