below thermostat housing little to left
What sensor?? most are held on with screws..
It is probably a bad speed sensor. The speed sensor is located on the transmission and sends a signal to the speedometer. It acts like a speedometer cable only sending electronic pulses instead of turning like a cable does.
In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.In June 1992.
It should fit but, the crank position sensor produces a signal by referring to the flex plate. In 1991 Jeep went to a Chrysler fuel injection system and the windows that the crank sensor reads are different. So in other words it should bolt up but then it will not start.
I just had the same problem with my '91 wrangler. It would sputter after it was warm and then not start once engine was off. I had to let it cool down for a good 2 hours. It was electrical. I needed a new crank shaft censor. After that she ran like an angel. I also got an injection flush. Good luck.
Yes.
It is screwed into the exhaust manifold on the rear of the engine.
Answeron the rear of the engine, towards the transThe cam sensor is in the distributor.
where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?
my sons 1995 new yorker with the same 'symptoms' was diagnosed with needing a crank sensor valve, parts charge $125 total with labour $300
In the gas tank
Yes, it is built on the starter.
remove glove box
5w30 or 10w30
10w3010w30
The camshaft position sensor on a 1992 Buick Regal looks like the end of a ratchet.
32 oz